5. Use hobby knife with sharp blade #11 and cut out cavities for
the blocks in both wing roots.
6. Shape the blocks before installation and test fit.
Use sandpaper and/or a knife and/or a rotary tool to completely fit
the blocks (loosely fit) to the wing’s contour.
7. Trial fit the blocks once again - adjust if necessary. Photo 6
4.Transfer markings to the other panel wing root. Photo 5
2. Find the two hardwood blocks. Place the blocks under wing
root, center each block under marks you made.
3. Mark the block width on the wing root foam and draw the wing
contour line on the block. Photo 4
The blocks will be hard points for the wing mounting screws.
9. Lay one wing half flat on the table.
10. Glue both blocks in place and wing halves together using 5
minute epoxy or 15 min. epoxy if you wish. Hold down both wing
halves together at the roots. Make sure that both wing panels
are aligned perfectly then raise wing tip 80 mm from the table
surface.
11. Wipe away all excess epoxy. Allow the epoxy to cure (at
least 30 minutes) then remove the masking tape.
12. Cut two strips 30mm wide and two strips 40mm wide from
glass cloth (supplied in the kit).
The cloth will reinforce the wing, top and bottom, around
the wing joint at the root.
Photo 8
P. 4
8. Use hobby knife with sharp blade #11 and cut out a narrow
groove in the foam under wing skin around both wing roots.
Photo 7
When two middle segments are joined-glued together the
groove will be filled up with epoxy creating a stronger center
joint
.
13. To keep the resin from spreading too far, apply masking tape
to the wing ~ 3mm away from the cloth’s edge. PHOTO 9
14. Mix a moderate portion of 20min. epoxy and using a small
brush or spreader stick apply epoxy to the top of the joint.
15. Lay prepared strips of glass cloth over the joint.
First lay the 30mm wide strip, then 40mm wide strip lay over.
Photo 9
P. 7
First layer
Second layer
P. 5
P. 6
P. 9
30
30
40
40
P. 8
Momentum-DL v.1
3
Содержание Momentum 1500mm SAL DLG F3K
Страница 1: ......
