4200 Series
LaserSource
User’s Manual · Page 7
Installation
Installation of the
LaserSource
is very straightforward, as the quick start section
above illustrated. This section will provide additional details and considerations
for installing your
LaserSource
.
After unpacking the unit, make sure all packing materials have been removed
and nothing obscures the ventilation ports on the back and bottom of the unit.
Changing the Voltage Selection
Before powering on the unit, ensure that the voltage selection on the IPC is set
correctly. Improper voltage selection can easily damage the unit. Changing the
voltage selection requires that you remove the selection tumbler from the IPC.
Input Power Connector (IPC)
Remove the power cord from the unit. Using a small flat blade screwdriver, open
the fuse panel. Remove the voltage selection printed circuit board on the right
side of the IPC (you may need needle nose pliers to do this).
Change the plastic guide to select the appropriate voltage. The selection is
counter-intuitive: you must place the plastic piece opposite the edge marked
with the voltage you wish to select:
CAUTION
Do not exceed 250VAC on the line input.
It is critical to select the proper voltage selection prior to
applying power to the unit. If the actual voltage exceeds
the voltage selection by +/-10%, damage to the unit
may occur.
Содержание LaserSource 4205
Страница 1: ......
Страница 26: ...Page 26 4200 Series LaserSource User s Manual Notes...
Страница 27: ...4200 Series LaserSource User s Manual Page 27 Notes...