Arneg Atlanta, Инструкция по установке и эксплуатации

Страница: 43 / 140

Atlanta
English
05060191 00 06-2021 16
20. 5 Clean specific materials
Material Remedy What to avoid
Glass • use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water and detergent with a dry
cloth in order to prevent marks
from forming and to prevent liquid
from reaching the gaskets, frame,
or the glass door hinges.
• DO NOT use hot water on cold glass surfaces;
the glass could crack and injure the operator
• DO NOT use rough or abrasive materials or
metal scrapers that could scratch the glass
surfaces
• DO NOT use dirty cloths
Procedure
for dis -
mantling
and clean-
ing sliding
closure
devices
Step Action
1 slide the glass lids towards the centre
2 move the lids upwards to make them come out from the lower rail guides
3 rotate the lower part towards the operator
4 remove the lids
5
gently place them on a flat surface protected by a soft cloth, DO NOT break or
damage them
6 clean glass, observe instructions in chap. 22
7
Clean the guides and frames at least once a day.
Observe instructions in chap. 22
8 Reinstall the closing devices
1 2 3-4
Plastic
(door seal
profiles)
• use a cloth soaked in neutral deter-
gent
• clean with a cloth soaked in clean
water
• DO NOT use waxes, concentrated deter-
gents, which contain oil, bleach, glass clean-
ers, abrasive detergents or flammable fluids.
Aluminium • use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming
• DO NOT use acid or alkaline detergents (e.g.
bleach) which could corrode the surfaces
• DO NOT use rough or abrasive materials or
metal scrapers that scratch the aluminium
surfaces
• DO NOT use steam cleaning equipment
• DO NOT use dirty cloths
Wood • before cleaning the entire surface,
test on a small hidden area and ver-
ify that the cleaner will not damage
the finish or colour
• use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming
• DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
• DO NOT use rough or abrasive materials that
could scratch the surfaces
• DO NOT use steam cleaning equipment
• DO NOT use rough cloths
• moderate the use of liquid detergent: over-
use causes seepage and then swelling of the
wood