Arlotto ANVR832, Руководство пользователя

Страница: 10 / 89

9
2.2 Hardware connection
1. Connect one end of the network cable to the gigabit network port.
Note: Make sure network port is connected to the network via network cable. They will obtain
IP addresses automatically via DHCP by default. You must enable the DHCP function within
your network, as the NVR unit will retrieve an IP address through. (The IP Address and
Netmask will default to 192.168.1.200, 255.255.255.0 for eth0 and 192.168.1.201,
255.255.255.0 for eth1 in case of no DHCP server existed)
2. Connect the other end of the network cable to your Ethernet hub or switch.
3. Connect the power cord to the power source.
4. Connect the power cord to the rear panel of the NVR unit.
5. On the front panel of the NVR unit, click the power button.
6. It takes about one to two minutes for the NVR unit to fully power up. Once it is powered up,
the Power LED will turn blue.
2.3 Setup NVR via Wizard
The NVR Setup Wizard (Setup Wizard program) performs the initial setup procedures on the
NVR unit. After this procedure, you can begin access NVR via NVR local console or Windows®
Remote client.
1. Get the NVR Client installation file.
2. Double-click NVR Client Installation.exe to begin installation.
3. Follow the instruction of NVR Client Installation.exe to install, or click the Exit button to close
the installer.
4. Click the Start button -> NVR Remote Client -> Setup Wizard.