Arjo AtmosAir 9000A, Инструкция по эксплуатации

Страница: 12 / 316

8
CPR
1. Level bed.
2. Disconnect hoses from pump to level mattress,
as shown at right (Figure 4).
3. /RZHURUUHPRYHVLGHUDLORQFDUHJLYHU¶VVLGH
if necessary.
4. Begin CPR as per facility protocol. Consider use
of backboard if indicated.
5. After CPR is performed:
• Remove backboard if used.
• Reconnect pump hoses to mattress.
• Raise or install side rail as necessary.
• 5HFRQ¿JXUHEHGDQGDFFHVVRULHVDVLQLQLWLDO
placement.
Transport Mode
When disconnected from the pump, the AtmosAir 9000A MRS will operate as a reactive
surface with the full operation of the SAT system. For transport, there are two options:
1. 'LVFRQQHFWWKHWXEHDVVHPEO\IURPWKHPDWWUHVV9DOYHVZLOOFORVHRႇDVVRRQ
as the tube assembly is disconnected.
2. Disconnect the tube assembly from the pump and securely place the transport
cap on the tube assembly to maintain a seal.
Skin Care
• Remove excess moisture and keep skin dry and clean.
•
&KHFNSDWLHQW¶VVNLQUHJXODUO\SDUWLFXODUO\LQDUHDVZKHUHLQFRQWLQHQFHDQG
drainage occur.
• Ensure linens under patient are not wrinkled.
Incontinence / Drainage
• Use moisture-impermeable underpads for incontinent patients.
• Wipe surface clean and replace bed linens as required (see
Care and Cleaning ).
General Operation
Avoid contact of sharp instruments with the AtmosAir
MRS. Punctures, cuts and tears may prevent proper
LQÀDWLRQDQGDLUSUHVVXUHPDLQWHQDQFH
Figure 4 Disconnect Hoses
Figure 5 Avoid Sharp Instruments