Aritech 2X Series, Руководство по эксплуатации

Страница: 18 / 36

14
Evacuation
If your control pane l is configured for evacuation control, evacuation is indicated
as follows:
• The Confirm LED is steady.
• The evacuation area alarm LED is steady if an evacuation alarm is active or
flashing if a confirmation delay is counting.
• The All Evacuation Start/Stop LED is steady if an evacuation alarm is active
for all configured evacuation areas.
Note: Evacuation panels only. This feature is subject to previous configuration by
your installation or maintenance contractor and operations associated with
programmable buttons and LEDs may differ from those described here.
Fault
Fault status is indicated as follows:
• The General Fault LED is steady and the corresponding feature or device
fault LED (if there is one) flashes.
• Mains and battery power faults are indicated by a flashing General Fault LED
and Supply Fault LED. Additional information about the fault is displayed on
the LCD.
• Earth faults are indicated by a flashing General Fault LED and a flashing
Earth Fault LED.
• System faults are indicated by a flashing General Fault LED and a steady
System Fault LED.
• Low battery faults are indicated by a flashing General Fault LED and a steady
Low Battery LED.
• Additional information about the fault is displayed on the LCD.
• The control panel buzzer sounds intermittently (long tone).
Note: Always contact your installation or maintenance contractor to investigate
the cause of a fault.
Disablement
Disablements are indicated as follows:
• The General Disable LED is steady and the corresponding feature or device
disable LED (if there is one) is flashing
• If a zone board is installed, the corresponding zone Disabled/Test LED is
steady (if the corresponding zone is included on the zone board)
• The control panel buzzer sounds intermittently (short tone)
For more information on the disablement, press F1 (Show Events) and then
select Conditions.