IPX-100 system installation & configuration
Page-18
TELECOMMUNICATIONS
After completing the “setup wizard” setting, the system will automatically pre-set the incoming
/outgoing call route and operator extensions as according to the PSTN line ports, regular corded
phone ports and key phone ports. The scenario are below 3 steps
1.
The incoming call routing table is specified the incoming call number (as set in the number table),
follow to the destination table setting (as like DID setting).
2.
The default of ring group digit: “9” as set in the group number table and auto assign the first 4
extensions for the ring group and follow to the incoming call routing table setting.
3.
The default of outgoing call digit: “0” in the outgoing call prefix code, this defines the extensions
to seize trunk lines as in used trunks table.
