PiCUS TreeQinetic Manual
12
Explanation of Parts
No. Designation
Function
1
Display
•
Displays menu
2
Direction Indicator
•
Indicates inclination direction
3
On / Off
•
Turn on / off
4
OK Button
•
Navigation in the menu
5
Status LED
•
Flashing during measurement
6
Ball Magnet
•
Attachment and alignment on inclino mount
7
Cable Socket
•
Connector for charge or data cable
8
Antenna
•
Radio connection
Table 5
– Inclinometer: Operation and Display Elements
Operation
The inclinometer is switched on or off by briefly holding the on/off switch. The display shows
the current measured value, the battery voltage and the module address. After switching on,
the firmware version, module address and the individual serial number of the respective
measuring instrument are temporarily displayed.
By pressing the OK button once, the Inclinometer changes to the offset mode ("zeroing"). By
pressing the OK button again, the five second calibration cycle of the offset value is initiated.
In most applications, it is recommended to have the offset value determined by a command
from the com unit for all modules simultaneously. Ideally, this is done immediately before the
actual measurement, the app does so automatically.
If the OK button is held down for 3 seconds, the Inclinometer switches to the address menu.
Here the module address can be set by pressing the OK button. To save the set address,
press and hold the OK button for three seconds.
