Page 6
SET-UP INSTRUCTIONS
IMPORTANT:
Do not connect the power cord until AFTER all other connections
have been completed! All connections must be made BEFORE the power is cycled
in order for the TV to recognize and properly initialize the wired remote control unit
or any accessories connected to the PVS.
1. Attach PVS to stand or mount per the instructions included with the stand or mount.
(Screws are included for your convenience)
2. Connect the cable to TV signal source. All on-air and most cable or satellite TV
systems use a coaxial line that connects to the antenna terminal of the TV.
(Threaded F-connector) This is marked on the back of the PVS with
ANT
. Screw
the coaxial cable snugly onto this terminal to ensure a proper picture and sound.
NOTE:
Video signal strength
must
be within the range of 0 +/- 8 dB for optimum TV
performance. Too high or low of a signal will result in poor picture quality and erratic
TV performance. If the signal provider requires the use of a converter box that does
NOT have a coaxial output, connect the source to the PVS via the component A/V
cables or with an HDMI cable. The RCA component AV connectors are marked
Y,Pb,Pr
and
L/R
. The HDMI connector is marked with
HDMI
.
3. Mount and Connect the Remote Control Unit. The ARG remote control is designed
to be mounted with most makes and models of cardio equipment. To mount the
control unit, first slide the cable ties through the appropriate holes in the mounting
bracket on the underside of the controller
. (Top to bottom if mounting it to a
horizontal bar; side to side if mounting to a vertical bar.)
Wrap the cable ties around one of the bars on the equipment in an appropriate
position. Take note how the equipment will be used and make sure the placement
of the controller will not interfere with the function or the range of motion of the
equipment.
