Arctic Cat ZR 120, Руководство по обслуживанию

Страница: 21 / 62

IO080A
5. Apply lightweight oil to the tappets; then install the
tappets to the proper guides as noted during disas-
sembly.
IO079A
6. Apply oil to the camshaft lobes and running surfaces
on each end of the shaft; then with the crankshaft/pis-
ton rotated to TDC and the timing marks of the crank-
shaft gear in-line with the camshaft gear, install the
camshaft.
IO078A
7. Install the washer onto the governor control shaft and
slide the shaft up into position from inside the crank-
case far enough to install the hairpin clip.
IO101

NOTE: When installing the governor control shaft,
position the shaft so the flat end (A) of the shaft is
directed to the cylinder (3 o’clock position) and the
hairpin clip (B) is in contact with the crankcase. This
limits the inward movement of the control shaft.
IO082B
IO093A
8. Install the shim washer to the crankshaft and place
the dowel pins and a gasket into position.
IO077