Arctic Cat ZR 120, Руководство по обслуживанию

Страница: 46 / 62

45
AG297D
2. Using a hammer, tap the end cap off the rail.
CLEANING AND INSPECTING
1. Inspect the end cap area of the slide rail for cracks
and wear.
2. Inspect the end cap for any signs of cracking or wear.
3. Clean both the slide rail area and the end cap. Using
compressed air, clean the areas of dirt and gravel.
4. Inspect the cap screw for cracked, stretched, or dam-
aged threads. Use a new lock nut when assembling.
INSTALLING
1. Position the end cap on the slide rail; then align the
hole in the end cap with the hole in the slide rail.
2. Secure with a cap screws, washers, and new lock nut.
Tighten to 78 in.-lb.
Wear Strip
REMOVING
 NOTE: Prior to removing the wear strips, inspect
each wear strip for wear. The wear strip must be
0.42" thick or thicker. If the wear strip measurement
is less than specified, replacement of both wear strips
is necessary.
0743-189

NOTE: A wear strip can be removed and installed
without removing the skid frame. To do this, remove
the machine screw and lock nut securing the wear
strip at the front of the slide rail; then align the wear
strip with openings (windows) in the track and drive
it rearward off the slide rail. Apply an all-tempera-
ture grease to the new wear strip and slide rail; then
align the wear strip with openings (windows) in the
track and drive it forward onto the slide rail. Secure
with the machine screw and lock nut.
1. With the skid frame removed, remove the machine
screw and lock nut securing the wear strip to the
front of the slide rail.
AG298D
2. Using a pipe wrench and starting from either end,
hook the edge of the wear strip with the pipe wrench
jaw and twist the wear strip off the slide rail. Move
the pipe wrench 3" and again twist the wear strip off
the rail. Repeat this procedure until the wear strip is
free of the rail.
 NOTE: The wear strip can also be driven off the
slide rail; however, using a pipe wrench is quicker.
CLEANING AND INSPECTING
1. Clean the slide rail using parts-cleaning solvent and
compressed air.
2. Inspect the slide rail for cracks. If any cracks are
found, replace the slide rail.
3. Using a straightedge, inspect the slide rail for any
unusual bends. Place the straightedge along the bot-
tom surface of the slide rail. If the rail is found to be
bent, it must be replaced.
4. Place the straightedge along the side of the slide rail.
If rail is found to be bent, it must be replaced.
INSTALLING

NOTE: Apply a light coat of grease to the slide rail
surface to aid in installing new wear strips. Use a file
to remove any sharp edges on the lower portion of the
rail.
! WARNING
Always wear safety glasses when using compressed
air.
! WARNING
Always wear safety glasses while using compressed air.