Arctic Cat 700 Diesel 2015, Руководство по обслуживанию

Страница: 28 / 155

26
DE047A
4. Adjust the handlebar direction until the two measure-
ments are equal; then secure the handlebar to the rear
rack using tie-down straps.

NOTE: Care must be taken not to allow the handle-
bar to turn while securing it.
CF361
5. Mark the center line of the front tires at the front and
the rear of the tire; then using a tape measure, mea-
sure and record the distance between the marks at the
front and rear. The front measurement should be 3-6
mm (1/8-1/4 in.) greater than the rear measurement
(toe-out).
CF345
6. Using an open-ended wrench to hold the tie rod (A),
loosen the right and left jam nuts (B).
CF344A
7. Turn the left- and right-side tie rods in equal incre-
ments to achieve proper toe out; then place a drop of
red Loctite #271 on the threads and while holding the
tie rod, tighten each jam nut to 35 ft-lb.
Front Rack
REMOVING
1. Remove the two shoulder screws and lock nuts
securing the front fender panel.
2. Remove the cap screws and lock nuts securing the
rack to the frame.
3. Remove the front rack from the ATV.
CLEANING AND INSPECTING
1. Clean all rack components.
2. Inspect all welds for cracking or bending.
3. Inspect threaded areas of all mounting bosses for
stripping.
4. Inspect for missing decals and/or reflectors.
INSTALLING
1. Place the rack into position on the frame and front
fender panel. Install the cap screws and lock nuts and
finger-tighten only.
2. Install the two shoulder screws and lock nuts secur-
ing the rack to the fenders. Tighten all hardware
securely.
Front Bumper Assembly
REMOVING
1. Remove the two flange bolts and lock nuts securing
the upper bumper supports to the bumper.
CAUTION
Always use a wrench to hold the tie rod in place when
loosening either of the jam nuts or damage to the boots
could occur.