Arctic Cat 700 Diesel 2015, Руководство по обслуживанию

Страница: 21 / 155

19
CD690A
3. Install one shoulder screw and three plastic rivets (on
each side) to secure the front of the rear body panel
to the footwells.
CD691
4. Connect the battery (positive cable first).
5. Secure the front and rear panels with two machine
screws; then install the left and right side panels.

NOTE: If the front body panel has not been
installed, see Front Body Panel/Side Panels in this
section.
6. Place the seat into position making sure it locks
securely.
Steering Post/Tie Rods
REMOVING
1. Remove the ignition switch retaining ring; then
remove the reinstallable rivets securing the instrument
pod to the mounting bracket and remove the pod.

NOTE: It is not necessary to disconnect any wires
from instrument pod components.
CD759
2. Remove the reinstallable rivets securing the radiator
access cover and remove the cover.
CD666
3. Remove the reinstallable rivets securing the steering
post cover and remove the cover.
4. Unlatch the storage compartment lid; then slide the
storage compartment cover assembly forward and
lift off.
5. Remove the four cap screws securing the handlebar
caps and instrument pod bracket to the steering post;
then move the handlebar out of the way. Account for
four handlebar caps.
6. Remove two cap screws securing the upper steering
post bearing to the frame. Account for two bearings
and two housings.
CD760
7. Using a suitable lift stand, raise the ATV enough to
remove the front wheels; then remove the left-side
and right-side splash panels.