8-9
8
AF785D
AF786D
NOTE: The distances from the inside rims to the
frame tubes should be equal. If the measurements
are equal, proceed to step 8; if the measurements are
not equal, proceed to step 7.
7. To make the measurements equal, loosen the appro-
priate tie rod jam nuts and adjust accordingly; then
tighten the jam nuts and proceed to step 8.
AF617D
AF778D
NOTE: The front wheels do not have to be removed
to adjust the tie rod. Also, care should be taken not to
disturb the handlebar position.
8. Using a permanent marker of some type, mark the
center of each front tire (at a height parallel to the
belly panel).
AF789D
9. Measure the distance between the marks (at a height
parallel to the belly panel) at the front side; then
record the measurement.
10. Push the ATV forward until the marks are parallel to
the belly panel on the back side; then measure the
distance between the marks.
11. The difference in the measurements must show
1/8-1/4 in. toe-out (the front measurement 1/8-1/4 in.
more than the rear measurement).
12. If the difference in the measurements is not within
specifications, adjust both tie rods equally until
within specifications.
NOTE: Prior to locking the jam nuts, make sure the
ball joints are at the center of their normal range of
motion and at the correct angle.
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
