3-31
3
CD069
14. Place the water pump into position and secure with
two cap screws. Tighten securely.
15. Install the crossover tube on the water pump and cyl-
inder head making sure the O-ring is properly posi-
tioned.
16. Install the shift arm on the shift arm shaft making
sure the scribed marks (from removing) are aligned.
Tighten securely.
17. Place the gasket and outer magneto cover into posi-
tion on the left-side cover; then tighten four cap
screws to 6 ft-lb.
Right-Side Components
NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
D. Oil Pump
1. Remove the cap screws securing the V-belt cover
noting the location of the different-lengthed cap
screws for installing purposes; then using a rubber
mallet, gently tap on the cover tabs to loosen the
cover.
CD079
2. Remove the nut and washer securing the movable
drive face; then remove the face. Account for a
spacer.
CD963
CD966A
3. Remove the V-belt.
4. Remove the nut securing the fixed driven assembly;
then remove the assembly.
PR388
AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
