Service Support Spirit
61
Unique Solution
WWW.ARCBRO.COM
No-pretreatment pattern——
The normal machining procedure is to machining program first to calculate
the maximum value and the minimum value of the pattern. However, it might take too long to handle a
large program. Therefore, it is allowed to set the maximum value and the minimum value of pattern in
advance without pattern pretreatment(see the parameters below). The system will machine the
workpiece when drawing the pattern.
X-axis width of steel plate ----
The actual width of steel plate along X axis, which is enabled only in running
extra large program.
Y-axis height of steel plate ----
The actual height of steel plate along Y axis, which is enabled only in running
extra large program.
Common edge option——
Since the system may control three kinematic axes, this option is used to
determine the 3rd axis(Z axis) shares a common edge with X axis or with Y axis for the machine requiring double-
edge drive. Take 0 to have Z axis and X axis share a common edge; take 1 to have Z axis and Y axis share a
common edge.
Metric/English system option ——
Take 0 for metric system, which will have length parameters, speed
parameters and values as well as coordinates expressed in metric unit(mm), though it supports machining
program in English system(G20). Take 1 for English system, which will have parameters, display and coordinates
expressed in English unit (inch), though it supports machining program in metric program(G21).
Attention: Please be cautious to make any change if no idea of the specific application of a parameter!
