Service Support Spirit
27
Unique Solution
WWW.ARCBRO.COM
8.1. Description of Automatic Mode Window
8.1.1 SPEED
1)
In automatic mode, at the top left corner of the screen, it shows F×(multiplying factor of automatic
machining speed)= set machining speed.
2)
In manual mode, at the top left corner of the screen, it shows F×(multiplying factor of manual
speed)=manual speed.
3)
SPEED indicates the actual speed while the active speed multiplying factor is adjustable with [F↑] and
[F↓].
4)
It is allowed to adjust the speed quickly by pressing [F] key in this window. A pull-down menu will appear
with 8 speed multi
plying factors available for selection with [↑] and/or [↓] key: 5%, 20%, 30%, 40%, 50%,
60%, 80% and 100%. And then, press ENTER key to acknowledge the selection.
5)
Attention:
The speed may be indicated in
Metric
or
English
system depending on the Metric/English
Selection in
SETUP
(Refer to
Parameter Control
).
8.1.2 PROG, PIERCE and KERF
They are used to indicate the name of machining program, serial number of pierced hole(automatic clear in
automatic machining mode) and the active compensating width of kerf respectively.
8.1.3 WORKMODE, OPERATE
WORKMODE field indicates the active operating mode such as rotation selection, breakpoint recovery,
mirroring and section selection.
OPERATE field indicates such information as machining/pause, limit alarms and time delay.
8.1.4 Input and output
Below the heavy-
current switches, there are 3 rows×8 indicators ○.
The top indicators show the status of 13 input ports, ○ indicating no signal input and ●
indicating signal input.
The bottom indicators show the status of 8 output ports, ○ indicating no signal output and ●
indicating signal output.
See the description of
DIAGNOSE
function for the definitions of input/output ports.
8.1.5 Machining Parameters Indication
This zone indicates various parameter values in the current machining mode.
