Service Support Spirit
37
Unique Solution
WWW.ARCBRO.COM
8.6.2Attention:
Never try to change the machining program, rotation angle and scaling proportion
whether it is breakpoint restoration or power-off restoration, which will be automatically
recorded by the system and free from affect by power-off operation; otherwise, the
system can not find the breakpoint.
8.7. SECTION(section selection)
8.7.1. Start SECTION function
SECTION: to assign system to start up machining operation from any section or piercing point.
Press [F1] to select SECTION function and the system will show a menu as shown in the figure below:
Move the cursor with [↑] or [↓] key and make one choice from two machining options.
According to your option, the system will prompt to input the serial number of the option (program
line number or the serial number of piercing point).
8.7.2. Two cases for SECTION machining option:
3.7.2.1Transitional machining: to start machining somewhere different from the start position of the
program;
3.7.2.2 Repeat the machining operation starting from a certain section of the program.
1)
For the former case, a scrap work piece is often used for aiming at the piercing point and machining
directly(
HERE POSITION
option);
2)
For the latter case, the reference point is used for positioning(
REF POSITION
option).
3)
For these two options, the system will prompt an option menu as shown below after start-up:
Fig. 8.5 SECTION function menu
Fig. 8.6 Option dialog box prompted by the system after machining start if SECTION machining is selected
