ARCA AIRPELLET, Техническое руководство

Страница: 42 / 61

2.7 TROUBLESHOOTING
Never disconnect the power supply of the stove until there is no flame and completed the post
ventilation. The post ventilation is required to burn all the embers and prevent unburned residues
that would dirty the stove and would make difficult switched back on.
FAULTS CAUSE REMOVAL OF THE
PROBLEM
DO NOT GET PELLET
IN THE GRATE PELLET TANK FINISHED
(THE WORDS "AL 5" IS SHOWN
FROM THE DISPLAY) EMPTY THE BRAZIERAND CLEAN.
FILL THE TANK OF PELLETS
AUGER LOCKED BY FOREIGN
BODY ES. NAIL, NYLON, PIECE OF
WOOD (THE WORDS "AL 5" IS
SHOWN FROM THE DISPLAY)
REMOVE POWER AND REMOVE
FOREIGN BODY.
NOT FREE OR FLUE TERMINAL
obstructing the passage of FLUE
GAS (THE WORDS "AL 8" IS
SHOWN FROM THE DISPLAY)
EMPTY AND CLEAN THE BRAZIER.
CHECK THE EXHAUST FUMES AS
THEY COULD BE BLOCKED
FLUE GAS TERMINAL CLOSED
BECAUDE OF A GRILL OR
TERMINAL WHICH PREVENTS THE
FREE TRANSFER OF FLUE GAS
(THE WORDS "AL 8" IS SHOWN
FROM THE DISPLAY)
EMPTY THE BRAZIER AND CLEAN.
CHECK THE EXHAUST FUMES
AND REMOVE THE GRILL OR
TERMINAL.
GUST OF WIND HAS DETERMINED
THE BLOCK OF APPLIANCE
(THE WORDS "TO 8" IS SHOWN
FROM THE DISPLAY)
EMPTY AND CLEAN THE BRAZIER
GIVE AND REMOVE POWER FROM
THE STOVE
THE ENGINE AUGER PELLET
DOES NOT WORK
REPLACE THE ENGINE AUGER
PELLET
THERMOSTAT WITH MANUAL
RESET HAS LOCKED THE STOVE
(THE WORDS "TO 7" IS SHOWN
FROM THE DISPLAY)
FAN EXCHANGER IS BROKEN AND
MUST BE REPLACED.
REPLACE THE FAN AND SWITCH
THE THERMOSTAT BEHIND THE
APPLIANCE
THE HEATER OFF AFTER A FEW
MINUTES FROM THE
CONCLUSION OF THE
PROCEDURE TO START ON DELAYED BECAUSE THE
AUGER WAS EMPTY (THE WORDS
"TO 5" IS SHOWN BY DISPLAY)
EMPTY THE BRAZIER AND CLEAN.
FILL THE TANK OF PELLETS
BRAZIER DIRTY
. IGNITION WAS WITH MUCH
DELAY
(THE WORDS "AL 5" IS SHOWN
FROM THE DISPLAY)
EMPTY THE BRAZIER
AND CLEAN FOLLOWING THE
INSTRUCTIONS IN THIS MANUAL
Procedure done as shown on page
load auger. 36 par. 2.5.7
42