Page 9
7
1
4
2 3
5 6
8
CHANNEL
7
1
4
2 3
5 6
8
4
1 2 3
6
5
7
8
4
1 2 3
6
5
7
8
4. Function Settings
A. TRANSMITTER HANDSET
1. System Channel Settings
(Fig. 07)
Set the transmitter channel by adjusting the channel dip-switch located on the backside of the transmitter
encoder board (refer to Fig. 07 above). Only the first six (6) positions are used for channel programming
(refer to Fig. 08 below). The system channels table located on page 30 illustrates which dip-switch
setting corresponds to which channel. Once the transmitter channel is altered do make sure to change
receiver channel as well. The channel on both transmitter and receiver must be identical in order for
system to work. To change receiver channel please refer to page 21.
Example:
Top slot
→
“1”
(Fig. 08)
Bottom slot
→
“0”
The above dip-switch setting
“1 0 0 1 0 0”
corresponds to “channel 36” in the system channels table on
page 30.
2. Continuous Transmitting Time Adjustment
After the push button is released the transmitter will continue to
(Type 1)
→
transmit neutral signals to the receiver for up to one (1) minute.
After one (1) minute the transmitter will cease transmission thus
temporarily disconnecting the receiver MAIN.
After the push button is released the transmitter will continue to
transmit neutral signals to the receiver for up to three (3) minutes.
(Type 2)
→
After three (3) minutes the transmitter will cease transmission thus
temporarily disconnecting the receiver MAIN. Please contact your
local dealer if your application requires transmitting on time other
than the preset value above.
Содержание FLEX 12EX
Страница 1: ...FLEX12EX User s Manual ...
