ARANA KAC 25, Инструкция по установке и эксплуатации

Страница: 41 / 60

Make A Difference 卓 / 尔 / 不 / 凡
EN
41
Unscrew and remove the roof vent.
Remove all caulking compound around opening.
Seal all screw holes and seams where the roof gasket will be located. Use a good
grade of all weather sealer.
A 362*362mm (+/-2mm) or 400*400mm (+/-2mm) opening must be cut through
the roof and ceiling of the vehicle if the existing vents will not be used. It is
recommended this opening be located between roof reinforcing members.
There may be electrical wiring between the roof and the ceiling. Disconnect 220V
AC power cord and the positive (+) 12V DC terminal at the supply battery. Failure
to follow this instruction may create a shock hazard causing death or severe
personal injury.
Mark a 362*362mm (+/-2mm) or 400*400mm (+/-2mm) square on the roof and
carefully cut the opening. Using the roof opening as a guide, cut the matching hole in
the ceiling. See FIG.04.
5.2 Roof preparation
Roof vent removal:
New opening ： (installation other than vent opening)
DANGER!
Opening instructions:
Wiring requirements:
a.
b.
If the opening exceeds 365*365mm, it will be necessary to install spacers.
If the opening is less than 358*358mm, it must be enlarged.
Route a copper 2.5mm², with ground, supply line from the fuse or circuit breaker box
to the roof opening.
The power supply must be on a separate 20 Amp Time Delay Fuse or HACR Circuit
Breaker.
Make sure at least 380mm of wire extends into the roof opening. This insures easy
a.
b.
c.
a.
b.