ARANA KAC 25, Инструкция по установке и эксплуатации

Страница: 38 / 60

EN
38
5.1 Choosing Installation location
This roof air conditioner is specifically designed for installation on the roof of a
vehicle with habitation compartments. The following points need to be considered to
determine the cooling requirements:
The size of the vehicle.
The size of the window (increases heat gain).
Amount of insulation in walls and roof.
Geographical location where the vehicle will be used.
Normal locations: the roof air conditioner is designed to fit over an existing roof
vent opening. When the vent is removed, it normally creates a 362*362mm (+/-2mm)
opening or a 400*400mm (+/-2mm) opening.
Other locations: When no roof vent is available or another location is desired, the
following is recommended:
For one unit installation: The roof air conditioner should be mounted slightly
forward of center (front to back) and centered from side to side. See FIG.01.
5.0 Installation instructions
Read installation and operating instructions carefully before attempting to start
your roof air conditioner installation.
The manufacturer will not be liable for any damages or injury incurred due to
non-compliance of the instructions.
Installation must comply with the national and local codes and/or regulations.
DO NOT add any devices or accessories to the roof air conditioner except those
specifically authorized in writing by
ARANA .
This equipment must be serviced by qualified personnel and some states require
these people to be licensed.
ATTENTION!
a.