Wet Stove Installation Guide
Now measure (as show in Figure 6 on the preceding page) the high end
of the damper plate between the bench and the top edge of the damper,
(the edge furthest from the control knob). This should be 29mm +/- 1mm,
if not adjust as follows:
• Slacken off the locking nut against the damper either in or out as
required.
• Check the distance at the high end of the damper plate again.
• Once set correctly re-lock the locking nut.
• Check the distance is still correct.
Once the correct distance is achieved please refit the damper flap
and thermostat by following the reverse of ’To remove the thermostatâİ
on 6.5.1 on page 14 and check once again that the correct distance is
maintained.
7
Maintenance
7.1
Removal of ash around the damper and thermostat
Regular checking and removal of ash from around the damper flap area,
inner left landing cavity and thermostat housing is necessary to ensure
correct operation.
To remove ash from around damper flap:
• Make sure the stove is unlit and cold.
• Remove the thermostat access cover as detailed on 6.5.1 on page 14.
• Carefully clean away any cold ash from the thermostat mechanism
and housing cavity using a vacuum cleaner.
• Refit the access cover.
BK555 Rev09
16
