Wet Stove Installation Guide
• Now remove the two M5 screws securing the thermostat to the stove
body. The thermostat should now be free and you will be able to
carefully remove it from the stove body.
• On the rear of the stove remove the thermostat sensor from its
pocket and push this carefully through the hole in corner cut-out of
the stove. (Take care not to kink the copper tubing.)
6.5.2
Calibrating
Figure 6: Checking damper flap distance.
With the thermostat removed, replace the control knob.
Rotate the control knob fully clockwise (as viewed with the damper shaft
to your left) until you reach the end of possible travel.
Place the thermostat on a flat surface with the base of the mechanism
body on a small piece of 8mm thick MDF or similar wood.
BK555 Rev09
15
