AR SMOOTH FLITE 16 RRS, Руководство пользователя, Страница: 41 / 61

41
Smooth Flite Detailed Functions: Ailerons
Aileron Hi and Low Gain
This is the level of Smooth Flite gain applied to the
aileron by the Master Gain Switch.
High Gain is used for low speed flying and landing
approaches. Low Gain is used for normal flying
conditions.
Many hours of flying have been undertaken by our
factory pilots to come up with default values which
have been to give good results.
Increasing gain levels to high with Auto gain Control
switched off may result in control oscillations.
Note: If you use the Auto Gain Control (AGC) feature then increasing these gain values may have little
effect as the auto gain feature will control the maximum level of gain applied by Smooth Flite.
Aileron Hi and Low Offset
Offset is a new feature that allows you to trim and
match end points of control surfaces for the 2 se-
lected gain positions of the Smooth Flite.
These values have been pre - set at the factory for
best performance with the factory set gain values.
If you alter High and/or Low gain values you may
have to adjust the Offset slightly to rematch end
point positions.
PLEASE NOTE— The High and Low Offset positions
feature is specific to the Gyro Gain function. It is a
separate feature to the servo outputs sub trim, travel and limit functions which effect overall output of
each channel in gyro and non gyro modes.