AR SMOOTH FLITE 16 RRS, Руководство пользователя, Страница: 25 / 61

25
Setting Fail Safe
Smooth Flite 16 has Fail Safe function which should be used for all receiver types.
Note: It is extremely important that FAILSAFE is set before flying. We recommend at least setting
FAILSAFE on throttle to either idle or off as a matter of safety.
Note: It is important to make sure that FAILSAFE is OFF or not set in the radio. If FAILSAFE is set in
both the radio and the Smooth Flite, you may experience servo jumping during a failsafe condition.
Note: In the Smooth Flite RRS, for FAILSAFE to occur, both receivers must enter FAILSAFE. If only one
receiver enters FAILSAFE then the system will function on the remaining receiver. This is one of the
outstanding safety features of the Smooth Flite RRS.
Step 1
Using the Smart Display, From the MAIN MENU
tap the RECEIVER button. Now tap FAILSAFE .
You should see the Fail Safe Page (picture on the
right). The
Blue bars will follow the stick positions
of your radio (just like the monitor screen).
The bars represent the first 10 channels outputted
from your radio.
Note: The bars have two colours.
Blue = FAILSAFE is set to heading hold. In a FAIL-
SAFE event the channel and associated servos will
hold the last good received channel value.
Green = FAILSAFE is set to a specific position. The
channel and associated servos will move to the pre
- set FAILSAFE channel value.
The default setting for all channels is heading
hold. (
Blue bars)
Step 2
To set failsafe on any channel tap on the channel
bar.
The blue bar will now turn green capturing the
current input channel position. Alternate tap-
ping of the Channel bar will cycle between
heading hold (
Blue bar) and FAILSAFE modes
( Green bar).
Below is an example of how to set FAILSAFE on
throttle assuming channel 1 is throttle:
On the Set FAILSAFE screen, move your throttle
transmitter stick, the blue bars above channel 1
will move. With your throttle stick at the Idle
position, tap the channel bar for channel 1.
The channel bar will now turn green.
you have successfully setup FAILSAFE for
throttle.
To test the FAILSAFE function is correctly set up
power off the transmitter. Channels set to FAIL-
SAFE should move servos to the pre
- set
position.
IT IS EXTREMELY IMPORTANT TO SET AND
TEST FAILSAFE PRIOR TO OPERATING THE
MODEL.