Aquila AT01, Руководство по обслуживанию

Страница: 31 / 50

MAINTENANCE MANUAL
AQUILA AT01
A
1. Wheel fairings - Check condition and correct fit. Remove and X
clean. Check for paint coat damage, cracks, dents and
delamination.
2. Fairing mounts - Inspect for cracks, distortion or other damage. X
3. Nose gear strut mount and wheel fork - Check for deformation, X
cracks and corrosion. Check nose gear strut journal bearing for
proper operation, play and correct safetying.
4. Nose gear strut and elastomer package - Check strut for X
deformation, stress marks, and cracks. Inspect correct
installation of the nose wheel fork. Inspect elastomer package
for wear, deterioration, cracks, correct fit and security.
Check journal bearings of the elastomer package for play and
condition.
Page 13
05-20-00
Maintenance Checks
16.09.19
No. Reference Interval Initials
100h other
Nose and Main Landing Gear
No. (Cont.) Reference Interval Initials
100h other
Empennage, Elevator, Rudder
3. Hinge play and control surface positioning - Verify clearance annual
between horizontal stabilizer and elevator horns and
clearance between vertical stabilizer and rudder horn is at
least 1 mm (0.04 in.). Check elevator hinge and rudder
hinge play. Maximum play approx.:
- Axial ± 0,30 mm (± 0.01 in.)
- Radial ± 0,30 mm (± 0.01 in.)
4. Elevator control system - Measure the play in the elevator annual
control system with the control surface locked. Apply a force
of 50 N (11.2 lb) forwards and then backwards to the control
stick - the maximum play allowed on the top of the stick is
10 mm (0.4 in.) for both sides.
5. Rudder - Remove rudder if there is noticeable play. 55-40-00 annual
Examine the elevator actuation assembly inside the vertical
stabilizer. Check for any damage, for correct installation
and function and for security and wear.
Inspect rudder hinge brackets, rudder yoke and control cable
thimble-eyes for security, conditions and wear.
Lubricate control cable thimble-eyes as required.
6. Rudder rigging - Set rudder pedals in neutral position. 27-20-00 X
Verify the rudder and the nose landing gear are also in
neutral position. Set rudder pedals to fully left and then
to full right. The rudder must hit the rudder travel stops
and the distance from rudder pedal to firewall must be
sufficient to apply the pedal brake. Adjust position of
the rudder pedals by varying the length of nose wheel
steering tubes. Adjust rudder neutral position and control
cable tension by means of the turnbuckles in the cabin area.