Aqua Simpool Pool-T, Инструкция по эксплуатации

Страница: 38 / 72

Simpool Pool-T Model INSTRUCTION AND MAINTENANCE MANUAL
Programmable digital peristaltic pump
ENGLISH
ADSP7000642 rev. 1.0 13/01/2014 38/72
1.0 INTRODUCTION
The range of
“Simpool”
programmable digital peristaltic pumps is designed to manage swimming pools and
consists of the following models:

POOL-T Model: for timed dosage

pH Model: for dosage proportional to the pH value

Rx Model: for dosage proportional to the Redox value

Timer Model: for weekly or daily programmable timed dosage
The Pool-T Model allows a simple, flexible and precise dosing of products for pools.
The pump can be programmed in 2 modes:
- D
OSING CYCLE
- R
ELAY
The "Dosing Cycle" mode allows to adjust the dosing depending on the time set, or the amount of product in
gr/
3
m
in the pool; the relay mode allows the dosing through direct control of the inhibitory signal coming from the
recirculation pump of the pool water.
1.1 WARNINGS
Before starting assembly, carefully read these instructions and follow them during installation.
Failure to follow the instructions of this manual may cause personal harm and damage to the device
and/or the system.
We recommend reading the label reported on the pump and following the directions below:

The pressure of the injection point must be lower or equal to the pump rated value!

When you receive the product, check the integrity of the pump and all of its parts. Should there be
any anomalies, promptly notify qualified personnel before performing any operations.

This manual must be kept in a safe place for future references.

Before installing the pump make sure that the details provided on the adhesive plate attached to
the pump correspond to those of the electrical system.

Do not use the device with wet hands or feet!

Do not leave the device exposed to the weather!

Make sure the peristaltic tube is compatible with the liquid to be dosed!

The device must be used by trained personnel!

If any irregularities are experienced during pump operation, cut off the power supply and contact
one of our customer care centres for any repairs!

In order for the pump to operate correctly it is necessary to use original spare parts or accessories.
The producer will not be held responsible for any fault or damaged provoked by tampering or non-
original spare parts and accessories

The electrical system must be complying with the standards of the Country it is installed in.

The operating ambient temperature must not exceed 40°C with a relative humidity of 90% at 90°C.
1.2 REFERENCE STANDARDS
Our pumps are manufactured according to General Standards in force and in compliance with the following
European Directives:

no. 2004/108/EC and subsequent amendments and additions.

no. 2006/95/EC
“DBT Low Voltage Directive” and subsequent amendments and additions.

no. 2011/65/EU , 2012/19/EU
“RoHs and WEEE directives” and subsequent amendments and additions.