3. Install connector cable lug rings onto the com-
munication posts (24) per the communication
posts pin configuration
(Fig. 9)
and
wiring diagram
(Fig. 11)
. Install the speakers left / right lug rings
onto the communication posts per wiring diagram.
Securely tighten communication post hex nuts to
communication posts with a 3/8" nut driver.
Figure 9
Mic
Speaker
(right)
Speaker
(left)
Figure 11
Installing Twist-On Connectors
1. Wire the microphone (30) to the connector cable
assembly (87 or 88) per the wiring diagram
(Fig.
11)
. Place stripped wires together with the ends
of insulation even. Twist connector (86)
(Fig. 10)
onto wires pushing firmly until hand-tight. Wipe
sealant in and around conductors and connector
open while tightening.
Figure 10
CAUTION: DO NOT overtighten the communication post hex nuts to the communication posts.
NOTE:
Twist-on connectors are internally treated with water proof sealant.
NOTE:
Pre-twisting connector cable wires is not necessary.
Figure 13
Figure 12
2. Hi-Use pin configuration
(Fig. 12)
and Marsh Marine pin configuration
(Fig. 13).
77
