Apex Digital XA3300, Инструкция по эксплуатации и запасным частям, Страница: 22 / 116

19
SHORT TERM STORAGE
1. Drain the slurry tank of all water and material prior to storage and leave the drain
plug uninstalled.
Hydroseed material can produce gases that are
harmful or deadly if inhaled. Empty the slurry tank
daily to prevent build-up of these gases.
Do not store material for long periods of time in
the slurry tank. Harmful or deadly gases could
result.
LONG TERM STORAGE
1. Drain the slurry tank of all water prior to storage and leave the drain plug uninstalled.
2. If possible, cover the machine with a tarp or park inside an enclosure.
3. Store the Applicator with all of the slurry valve handles in the open position. To
prevent damage from freezing, remove all of the slurry valves and store in a heated
area.
4. Pour 1 Qt. (0.95 L) of mineral oil or environmentally safe lubricant into the pump
housing and spin the pump to prevent rust in the pump. Remove the drain plug.
5. Lubricate all fittings.
6. Check the antifreeze in the radiator and add as necessary.
7. Lubricate the equipment again just prior to putting back into operation after having
been in storage.
8. Change hydraulic oil and filter (500 hours).
9. Disconnect the battery cables. In cold weather, remove the battery and store it in a
safe, warm place.
10. Add fuel stabilizer to the fuel tank.
ENGINE STORAGE
The long term storage of an engine without adequate preparation will cause damages to
external as well as internal components. Refer to the engine manufacturer
documentation for the appropriate storage procedure.
DISPOSAL PROCEDURE
• Do not discard into municipal waste stream.
• Disassemble and contain hydraulic components in approved container.
• Discard through a licensed processing facility.