6
code HG0141.00GB ed.A-2008
LRP - RAPID PRO and LK - KONDENSA
LRP and LK WARM AIR HEATER
2.7. Unpacking
The unpacking operation must be carried out by using suitable
tools or safety devices where required. Recovered packaging
materials must be separated and disposed of according to ap-
plicable regulations in the country of use. While unpacking the
unit, check that the unit and all its parts have not been damaged
during transport and match the order. If damages have occurred
or parts are found to be missing, immediately contact the sup-
plier. The manufacturer is not liable for any damages occurred
during transport, handling and unloading.
Packing material disposal
The packing safeguards the product from transport damages. All
the materials used are environmentally friendly and recyclable.
Please contact a specialised distributor or your local adminis-
tration for more information on waste disposal.
2.8. Disposal and Demolition
Should the machine be dismantled or demolished, the person
in charge with the operation shall proceed as follows:
Disposal of end-of-life products
This equipment is marked in compliance with Eu
-
ropean Directive 2012/19/EU on waste electrical
and electronic equipment (WEEE). This Directive
defines the rules for collecting and recycling waste
equipments throughout the entire territory of the
European Union.
WEEE contains both pollutants (that can negatively affect the
environment) and raw materials (that can be reused). IT is there-
fore necessary to subject WEEE to appropriate treatments, in
order to remove and safely dispose of pollutants and to extract
and recycle raw materials. IT is forbidden to dispose of WEEE
as unsorted waste. These operations facilitate recovery and re-
cycling of the materials, thus reducing the environmental impact.
NOTE: All materials recovered will be processed and
disposed of according to what provided for by the laws
in force in the country of use and/or according to the
standards indicated in the safety sheets of the chemicals.
INFORMATION FOR DISPOSAL valid in ITALY (Legislative
Decree 49/2014)
The heaters and relating accessories are considered “profession-
al WEEE - waste electrical and electronic equipment”. According
to the legislation in force in Italy, professional WEEE must be
sent to treatment plants suitable for these types of waste. Please
contact the Apen Group for end-of-life products so as to obtain
all the information necessary for their correct waste disposal,
which is possible thanks to the Collective System (Union) to
which the company is associated. Please remember that product
disposal without complying with the mode described above is a
violation liable to administrative and penal sanctions.
INFORMATION FOR DISPOSAL valid abroad (EU COUN-
TRIES except Italy).
The European Directive 2012/19/EC shall be implemented in
every EU member state. There may be different application
modalities for the various member states, even in terms of
modality for waste disposal depending on its type (House-hold
or Professional WEEE). To this regard at the end of the life of
the product, we highly recommend you call the distributor or
installer so as to obtain information on the correct disposal, in
compliance with the existing laws of the installation country.
2.9. Installation
The LK and LRP heat exchanger must be used in the following
conditions:
•
The fuel used must have a sulphur content according to
the European standard, namely: maximum peak, for short
periods, 150 mg/m
3
, annual average lower than 30 mg/m
3
;
•
Combustion air must not contain chlorine, ammonia, alkalis
or sulphides; for example, installation near swimming pools
or laundries exposes the unit to the effects of such agents;
if this is the case it is necessary to take air from the outside.
