aoyue INT 2703A+, Инструкция по эксплуатации

Страница: 29 / 32

29
BASIC TROUBLESHOOTING GUIDE
Case 3:
The Suction Vacuum cap is connected to the Smoke Absorber
Terminal or Vacuum cap instead of the Wire mesh cap.
SOLUTION:
Change the cap to the Wire mesh cap. This allows more air to pass through the
system. Make sure as well that the vacuum tube of the soldering iron or
desoldering gun is not connected.
Case 4:
The Wire mesh cap is connected but airflow level is still low.
SOLUTION:
Check the filter pad inside for dirt that can block the air passage. Clean or
replace if necessary.
ADDITIONAL SOLUTION:
Check for any tangles in the tube of the hot air
gun that can cause the air blockage.
PROBLEM 8: UNIT SHOWS UNCONVENTIONAL BEHAVIOR
Description: Unit operates erratically.
SOLUTION1:
Try to switch OFF the device and switch ON again. Unplug the
system from the main power source and plug in again when necessary
SOLUTION2:
Restore unit to default factory setting. switch off/on the unit
while holding the hot-air temperature down button until the banner finishes
scrolling, the unit would revert to its default factory setting.
OTHER PROBLEMS NOT MENTIONED:
Contact the vendor.