-B284SB0*1K**P30 7/16-
①
A
A
B
②
③
A
B
＜
Panel mounting procedure
＞
Put the mounting frame over the front of the sensor body, and fasten the frame at
the positions of grooves A.
A: Mounting frame fastening position
B: Mounting bracket fastening position
Sensor body
Mounting frame
Mounting panel
(1 to 6mm)
Mounting bracket
Insert the sensor body with the mounting frame into the panel hole, and put the
mounting bracket from the back of the panel. Fasten the mounting bracket with
groove B while adjusting the mounting position.
- This terminal is intended for use in connection with the AnyWireASLINK
transmission line.
Even if this terminal is directly connected to an I/O card of PLC, etc., it does not
work.
- Use this product in the proper voltage range.
- The transmission line included in the sensor body shall be included in the total line
length.
- For address setting, make sure that the specified number of transmission points is
not exceeded. If the specified number of transmission points is exceeded,
detection is disabled.
- Before connecting the pipe to this terminal, eliminate dust remaining in the pipe by
air blow.
- If foreign objects may enter the fluid, connect a filter or mist separator to the inlet of
the pipe (source pressure side).
[Installation Location]
[Precautions for Use]
- Locations where this product is not directly subject to vibration or shock
- Locations where this product is not directly exposed to dust
- Locations where this product is not directly exposed to conductors, such as metal
chips or spatters
- Locations without condensation
- Locations where the atmosphere is free of corrosive gases, flammable gases, and
sulfur
- Locations far from high-voltage or high-current cables
- Locations far from servos, inverters, and other cables and controllers that
generate high-frequency noise
