Anthem AVM 2, Руководство по эксплуатации

Страница: 51 / 70

46
7. ADVANCED SET-UP
continued …
7.4.8 TRIGGERS / IR / RS-232
Three Trigger Outputs are provided on the back of the AVM 2. These allow you to remotely turn other
components on or off, such as Power Amplifier, CD Changer, Video Projector, etc. To have their power On/Off
controlled by the AVM 2, simply connect a Trigger output from the AVM 2 to the Trigger input of the other
component. For components that do not have a trigger input, use a triggerable power bar (see your d e a l e r ) .
The Triggers menu allows you to determine the criteria by which other components are turned on or off .
There is a quarter of a second delay between each trigger to minimize momentary line voltage drops caused
by switching on too many devices at the same time.
• Trigger1 and Trigger2: Provides standard trigger outputs of 12 volts with up to 50mA , suitable for
typical source components and most amplifiers.
• Trigger3: Provides a standard trigger output of 12 volts with up to 200mA source current, suitable
for motorized projector equipment and very high power amplifiers.
• All 3 Triggers: Require a mono 3.5mm mini plug to the AVM 2, and usually the same at the
component end.
(menu 8.a) All Triggers:
Allows you to ‘Enable’ or ‘Disable’ all Trigger options for MAIN and ZONE2, regardless of their settings. You
can also select ‘RS-232 Ctrl’ which allows external control over the Enable / Disable condition for all triggers.
(menu 8.b-d) SET TRIGGER 1, 2, 3:
When you select Trigger 1, 2, or 3 the following control chart appears for each trigger:
8. TRIGGERS / IR / RS-232
a. ALL TRIGGERS : Disabled
b. SET TRIGGER 1
c. SET TRIGGER 2
d. SET TRIGGER 3
e. FRONT IR : Enabled
f. REAR IR : Enabled
g. BAUD RATE : 19200
h. FLOW control : None
i. RS-232 TX STATUS ON : No
8b. SET TRIGGER 1(2or3) SOURCES
M Z2 R M Z2 R
PWR ON - - FM/AM - - -
DISC1 - - - TV - - -
DIRECT - SAT - - -
DISC2 - - - VCR - - -
TAPE - - - AUX - - -