Anthem AVM 2, Руководство по эксплуатации

Страница: 33 / 70

6. REMOTE CONTROL OPERATION
Dr. Jekyll and Mr. Hyde, as you may know, were two
very different personalities, even though they were
the same person. Well, the AVM 2 Remote Control
is the host to NINE different personalities! (All of
them ‘good’, of course.)
The AVM 2 Universal Learning Remote Control has
all of the same functions as the front panel keys and
is operated in a similar way, but there are some
d i ff e rences. Please take the time to read this
section to fully understand all that the AVM 2
Remote Control can do.
The keys labeled in this illustration show those that
have a
d i ff e re n t method of operation from their fro n t
panel counterparts. Those shown in bold italics
indicate keys that are unique to the Remote Contro l
and not found on the Front Panel. For a detailed
layout diagram see section 3.3.
B e f o re we get started, we have to give the remote a
little attitude adjustment – set the ‘personality’ to
MAIN. Press
M A I N in Zone/Path/Component near
the top of the remote.
N o t e : The Zone/Path/Component keys do not
transmit any commands to the AVM 2, or
a n y w h e re else. They only determine where
subsequent commands are sent. For example, if
ZONE2 is selected followed by VOL+, then the
volume changes in Z O N E2 while MAIN and all
other components remain unaff e c t e d .
Did we forget to mention the batteries? They go in
by taking off the rear cover
– remember polarity.
Down the road, if the keys don’t light up when
they’re pressed, and the red LED blinks twice, it’s
an indication that the batteries need replacement.
6.1 POWERING THE AVM 2 ON AND OFF
Because separate power commands are a requirement in custom multi-zone
and home theater installations,
two different keys are used to turn the AVM 2 ON and OFF.
The power key in the top right corner turns the AVM 2 Power ON. The red SSP OFF key in towards the
middle turns the AVM 2 Power OFF.
The AVM 2 can be turned ON and OFF as follows:
• MAIN ON – P ress M A I N in Zone/Path/Component, then press .
• MAIN OFF – P ress M A I N in Zone/Path/Component, then press SSP OFF.
• ZONE2 ON – P ress Z O N E 2 in Zone/Path/Component, then press .
• ZONE2 OFF – P ress Z O N E 2 in Zone/Path/Component, then press SSP OFF.
28
Zone/Path/Component
(‘Personality’)
Sleep Timer
Source Seek
FM/AM Presets
SSP REC Path
IR Transmitter
Power ON
Red Indicator LED
Learn Key
SSP Power OFF
MAIN Source Copy
SSP Input Sources
• FM/AM Seek / Tune
• Level / Bass / Treble /
Balance Adjustments
• Effects Selection
• Setup Menu Navigation
Time Display
FM/AM Presets
UP / DOWN
FM/AM Direct Entry