ArcSource Outdoor 24 MC Integral SmartWhite
16
HoLd DMX
--- If the function is on, the last received DMX values are held in case, that DMX data receiving was
interrupted (e.g. disconnected DMX controller).
Flicker Free M
---F
licker free mode.
If the function is on, the light flickering visible in cameras is corrected but
colour uniformity is worse.
SW Upd
---
Software update
. The menu item allows you to update software in the fixture via either serial or USB
port of PC.
The following are required in order to update software:
- PC running Windows 95/98/2000/XP/7/8 or Linux
- DMX Software Uploader
- Flash cable RS232/DMX No.13050624 (if you want to use a serial port of PC)
- Robe Universal Interface (if you want to use an USB port of PC)
Note1: Software update should execute a qualified person. If you lack qualification, do not attempt the update
yourself and ask for help your Anolis distributor.
Note 2: DMX address, programs and all items in the menu "PErS" will be set to their default values.
To update software in the fixture:
I
. Installation of the DMX Software Uploader.
1.
DMX Software Uploader program is available from the Anolis web site at WWW.anolis.cz.
2
. Make a new directory ( e.g. Anolis_Uploader) on your hard disk and download the software into it.
3
. Unpack the program from the archive.
II.
Fixture software updating.
1.
Determine which of your port is available on your PC and connect it:
-
with the DMX input of the fixture if you using the flash cable RS232/DMX
-
with the DMX input of the Robe Universal Interface if you using the USB cable.
Disconnect the fixture from the other fixtures in a DMX chain. Turn both the computer and the fixture on.
Make sure the lamp is switched off (only if the fixture involves a lamp).
2.
Switch the fixture to the updating mode:
1
Use the UP/DOWN buttons to find “
SPEC.
“ menu.
2
Press the ENTER button.
3
Use the UP/DOWN buttons to select “
uPd.
“ item.
4
Press the ENTER button
5
Use the UP/DOWN buttons to select “
yES
“ option
6
Press the ENTER button
Note: If you do not want to continue in software update, you have to switch off and on the fixture
to escape from this menu.
3
. We recommend to cancel all running programs before start of the Software Uploader.
4
. Run the Software Uploader program. Select desired COM and then click on the Connect button.
