AWG08-001 Cabin PA Amplifier
Installation and Operation Manual
January 21, 2019 Rev: 1.01
Page 1-6
ENG-FORM: 800-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
1.3.6
Warning Audio Test [Non-TSO]
The AWG08 includes a warning audio test (WARN AUD TEST) feature with a user configurable input state.
When triggered, warning audio test plays back all stored warnings/messages in priority order. The test
feature tests audio playback only.
The AWG08-001 user configurable input pin state is pre-loaded from factory with the following:
Input Pin
State*
Warning Audio Test
Active Low
*Note:
The state is user configurable between “Active High” or “Active Low” trigger types.
1.3.7
Warning Trigger Disable [Non-TSO]
The AWG08 includes a warning trigger input disable feature with a user configurable input state. When
triggered, all warning audio input triggers (trigger 1 through trigger 8) deactivate and no longer trigger
warning message playback. Warning trigger input disable (WARN TRIG DISABLE) does not interrupt
warning playback but does cancel any warning set to repeated playback.
The AWG08-001 user configurable input pin state is pre-loaded from factory with the following:
Input Pin
State*
Warning Trigger Disable
Active Low
*Note:
The state is user configurable between “Active High” or “Active Low” trigger types.
1.3.8
Slave Input [Non-TSO]
The AWG08 includes a slave feature which is not user configurable for input state and only detects an
active low trigger. If the slave feature is triggered the AWG08 enters a suspended playback mode and will
act as a secondary (slave) device. The master output is triggered when the slave input is triggered to
cascade priority. During this mode, the AWG08 will accept and remember triggered warnings but will not
play back the warning regardless of warning type (repeating or single shot). Once the slave pin is
released, the secondary (slave) AWG08 will playback all active or previously active warnings in priority
order.
The slave feature is disabled by default. The slave setting is configured using the “Enable Master/Slave
control” under audio settings in AWG-APS. The AWG08-001 user configurable setting is pre-loaded from
factory with the following:
Audio Setting
Check Box*
Enable Master/Slave Control
Unchecked
*Note:
Disabling Master/Slave Control disables the slave input as well as the external
warning active input.
