Anodyne Electronics Manufacturing AWG08-001, Инструкция по установке и эксплуатации

Страница: 10 / 41

AWG08-001 Audio Warning Generator
Installation and Operation Manual
January 21, 2019 Rev: 1.01 Page 1-5
ENG-FORM: 800-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
1.3.4 Warning Audio Cancelation [Non-TSO]
The AWG08 is capable of canceling repeated warning playback. Single shot warnings playback once for
each trigger event and cannot be canceled. All repeating warnings playback a minimum of one time. Each
warning must playback over its entire duration and will not be interrupted by warning audio cancel. Warning
cancelation only cancels the repeating event, not the warning.
The AWG08-001 user configurable cancel input setting is pre-loaded from factory with the following:
Input Pin Cancel Setting*
Warning Audio Cancel Input Enabled
*Note: Disabling the Warning Cancel Input also disables all trigger cancel modes below.
The AWG08-001 user configurable trigger cancel mode is pre-loaded from factory with the following
settings:
Trigger Cancel Mode*
Trigger 1 Enabled
Trigger 2 Enabled
Trigger 3 Enabled
Trigger 4 Enabled
Trigger 5 Enabled
Trigger 6 Disabled
Trigger 7 Disabled
Trigger 8 Enabled
*Note:
The trigger Cancel Mode is user configurable between “Enabled” or “Disabled” Cancel
types for each trigger individually.
1.3.5 Warning Trigger Inputs [Non-TSO]
The AWG08 has up to eight individual warning trigger inputs. Each warning trigger input plays back the
respective warning audio when the input detects a voltage signal level which is user configurable. The
configurable input state can detect a change from NULL/POS to GND (Active Low) or from NULL/GND to
POS (Active High) transition.
The AWG08-001 user configurable input trigger state is pre-loaded from factory with the following:
Input Trigger State*
Trigger 1 Active Low
Trigger 2 Active Low
Trigger 3 Active Low
Trigger 4 Active Low
Trigger 5 Active Low
Trigger 6 Active Low
Trigger 7 Active Low
Trigger 8 Active Low
*Note:
The state is user configurable between “Active High” or “Active Low” trigger types for
each trigger individually.