Chapter 9 : CONTROL SOFTWARE SMART CUT 2™
PAGE 24
9-1. CONNECTION (continued)
•
PIN-OUT:
PIN #
FUNCTIONS
2
TRANSMIT DATA (Tx)
3
RECEIVE DATA (Rx)
5
GROUND (Gnd)
8
+12 Vdc (power of the RK-20)
DB 9 female
(Rear panel of the SMART CUT 2
™
)
•
SPEED TRANSMISSION:
9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.
9-2.
"SMART CUT 2
™
REMOTE CONTROL" SOFTWARE
Your SMART CUT 2
™
is shipped with a WINDOWS (95/98/2000/Me/XP) compatible "SMART CUT 2
™
REMOTE
CONTROL" software (3.5" disk). This software allows you to control and make adjustments by a simple mouse click
(output format, image adjustments, etc...).
•
SOFTWARE INSTALLATION:
c
Turn your computer ON and wait for WINDOWS to completely start.
d
Insert the disk into the floppy drive.
e
In the WINDOWS
START
menu, click on
RUN
.
f
Choose the disk drive and click on
setup.exe
(ex : A:\
setup.exe
if disk 3.5" is drive A).
g
Follow the WINDOWS installation instructions. WINDOWS will create a file C:\Programfiles\ANALOGWAY\
SMART CUT 2 remote control.
•
STARTING UP:
c
Connect the RS-232 cables between the control device and the SMART CUT 2
™
as indicated in section 9-1.
d
Then only power ON all of the devices.
e
Click on the program files
S-CUT 2
in
Start-program-ANALOGWAY-SMART CUT 2
to run the software.
f
Click on
Control
menu and select the
Serial port
.
The SMART CUT 2
™
is now connected to the computer (if not, verify the DB9 serial connection and the
selected serial port).
