Battery Removal and Replacement
20
Battery Replacement & Firmware Upgrade - 5.2” Modero ViewPoint Touch Panels
3.
Reattach the back cover, engaging the hook on the lower left of the case (near the speaker) and using it to
swing the back cover down into place.
4.
Insert the five screws and replace the rubber feet atop the two upper screws, using the replacement rubber
feet included in the Battery Pack Kit (FIG. 4).
5.
Replace the bottom label over the three bottom screws, using the replacement label included in the
Battery Pack Kit.
6.
Restart the device to confirm that the new battery is functioning correctly.
Special care must be taken to seat the battery plug so that it does not damage or rub
against the two resistors near the battery connector. When connecting the battery, do
not allow the battery plug to rub against the circuit board.
When reassembling the device, take care not to pinch or squeeze the connector
wiring or the battery. Do not force the back cover onto the device, as this can damage
the device.
The three bottom screws are shorter than the top two screws. The screws must be
re-assembled in their original location or the device can be damaged during
reassembly.
FIG. 4
MVP-5200i back cover installation
Rubber feet
Upper screws
Bottom
Bottom
Front of MVP-5200i
Back cover
Bottom
screws
Speaker
screw holes
label
