Programming
52
Metreau Keypads Instruction Manual
Terminal Commands (Cont.)
Command
Description
GET CONFIG
Display the current connection settings.
Example:
>get config
Device number: 10001
Connection Settings
--------------------------------
ICSNet/Ethernet: Ethernet
Mode: URL
System Number: 1
Master IP/URL: 192.168.1.211
Master Port: 1319
Username:
Password:
IP Settings
--------------------------------
HostName: localhost
Type: DHCP
IP Address: 192.168.1.53
Subnet Mask: 255.255.255.0
Gateway IP: 192.168.1.1
MAC Address: 00:60:9f:94:2d:4f
DNS Servers
--------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.20.7
Entry 2: 192.168.20.9
NOTE:
The system number and IP addressing information displayed is reflective of actual
operating values, not stored parameters.
GET CONNECTION
Show the Module connection information.
Example:
>get connection
Connection Settings
------------------------------
ICSNet/Ethernet: Ethernet
Mode: URL/TCP
System Number: 1
Master IP/URL: 192.168.1.211
Master Port: 1319
Username:
Password:
GET DEVICE
Display the device number.
GET DNS
Get list of DNS entries.
Example:
>get dns
DNS Servers
-------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.20.7
Entry 2: 192.168.20.9
NOTE:
When the module is in DHCP mode, these are active values, NOT the stored values that
only apply to static mode.
GET ETHERNET MODE
Display the current LAN configuration setting.
Settings are either "auto" in which the LAN driver will discover it's settings based on the network it
is connected to OR <speed> and <duplex> where speed is either 10 or 100 and duplex is either full
or half.
Example:
>GET ETHERNET MODE
Ethernet mode is auto.
NOTE:
See the SET ETHERNET MODE
command on page 54
.
GET FRIENDLY <name>
Displays the Module’s friendly name (for NDP).
