background image

Tel 01442 230 800   www.bpt.co.uk

PTDC70 & 50 MBPT Keypad 

Quick Start Programming Instructions

Set the Keypad into Programming Mode with The Factory Set Master Code 0 0 0 0
  
       ---- 

Listen for the 2 rapid beeps - The keypad is now in programming mode.

NOTE: If the Master Code is forgotten, use the DAP Code to set the keypad into programming mode. 
(See DAP CODE 8080 in the main instructions for the details).

Change The Factory Set Master Code to the Owner’s Private Master Code for Security Reasons
 

 

                  ---- 2 rapid beeps,  (1 2 3 4 is a Master Code for example here only)

1 2 3 4  is now the new Master Code and the factory set default of  0 0 0 0  is erased.

Set a “User PIN” to Operate The Output 1 (relay 1) for Door Open

   (a)  

    (b) 

            (c)                         (d)           (e)

(a) 

10 = Programming Location for Output 1 (relay 1)

(b) 

2 = Programming for User PIN

(c) 

0 0 1 = One of the 1,000 User indexes for the User PIN ranging from 000-999

(d) 

4 3 2 1 = The User PIN that is programmed for the door.

 (4 3 2 1 is a User PIN for example only)

(e) 

# = Confirm the User PIN, (listen for 2 rapid confirmation beeps after pressing #)

NOTE:   A User PIN can not be the same as the Master Code

REMARK:
If more User PINs are required for output 1, repeat procedure 3 (above) with other User indexes, 
such as 002, 003, 004 --- 999 etc.  A total of 1,000 users are allowed (See Programming Location 10 
for the details in the main instruction booklet)

Exit The Programming Mode
    
         ---- Listen for 2 rapid confirmation beeps
The programming mode is complete and the keypad is back to normal operation mode.

OPERATION

Open The Door with The User PIN (The door will release for the factory default time of 5 seconds)
 

                 ---- 1 long beep, the door is now open

REMARK:
To change the private master code or “User PIN” - simply repeat procedures 2 and 3 (above). 
For all other keypad programming features and functions including door release times, please 
refer to the main instruction booklet. 

PROGRAMMING NOTE: 

When powering up please wait 1 minute

 until the end of the power up delay and the keypad stops beeping

.

!

AA AAAA  A

0 1   1 2 3 4

AA  A 

AAA  AAAA A

1 0

2

0 0 1

4 3 2 1

AAAA A

4 3 2 1

AAAA  AA

0 0 0 0

* *

AA

* *

1

2

3

4

5

Reviews: