Reader Installation Manual
Installation Procedures:
1.
Make sure the antenna module is plugged into the main body. After that, connect the wire.
2.
Put the main body inside the gang box as shown in Figure 1.
Please note that the arrow symbol should be pointing upward.
3.
Install the front plate onto the main body. To install the front plate correctly, please attach the top of the front plate first
(refer to Figure 2). Then proceed to push the bottom into the main body (refer to Figure 3).
Specification:
Recommendation:
1.
Use 12V DC Regulated Linear Power Supply.
2.
Use 6 Core 22AWG Shielded Twisted-Pair Cable.
3.
Connect the Drain Wire to the ground of system side (as shown in Figure 4).
Voltage Input (located at
the bottom of the reader)
DC10V ~ 15V
Standard Read Range
> 5cm
Operating Current
120mA (max.)
Max. Cable Length
150m
Operating Temperature
-10ºC ~ 60 ºC
Format of Number Pad
4 bits burst (default)
Figure 2
Figure 3
Figure
1
Arrow symbol upward
Antenna
Figure 4
