Configuring Metreau Keypads with Ethernet
43
Metreau Keypads Instruction Manual
Resetting the Keypad
To perform a factory reset of the Keypad, press and hold buttons 1 and 2 for approximately 10 seconds during the boot process.
The LEDs on buttons 1 and 2 blink while you keep them pressed. Hold them until the LEDs begin blinking at double the rate
(approximately 10 seconds.) Release the buttons and the keypad will reset. During factory reset, the backlight turns off for all
buttons, but all buttons should be back online after 1-2 minutes. If you do not hold in the reset button until the LEDs begin blinking
faster, the reset does not occur. (There is no soft reboot with the Reset button, but you can perform a soft reboot from the web
pages.)
NOTE:
When you reset a keypad, the keypad is restored to the factory default, so you will lose all configuration data as the defaults
are restored.
Restoring the Factory Image on the Keypad
To restore the factory image on the keypad, press and hold buttons 1 and 2 for approximately 20 seconds
during the boot process.
The LEDs on buttons 1 and 2 blink slowly while you keep them pressed, and they begin to blink more quickly after 10-12 seconds.
Hold the buttons until the LEDs stop blinking (approximately 20 seconds.) While pressing the buttons, disconnect and reconnect
the cable from the LAN port on the rear panel of the device to restore the factory image firmware on the keypad.
