![background image](http://html1.mh-extra.com/html/amx/dcp-mtx/dcp-mtx_user-manual_2939027031.webp)
31
USER MANUAL
DCP-MTX
CEC Auto-Control ON/OFF: Click to enable or disable CEC Auto Control. When
enabled, DCP-MTX will send a CEC command to turn off the display connected to
HDMI OUT when there’s no signal present after a defined Delay Time or turn it on
immediately when there’s active signal.
Delay Time (min): Set the delay time of turning off the display after it receives CEC
command from DCP-MTX. The time is 0 - 30 minutes.
CEC Manual Control: Click to turn on or off the display manually.
2) RS232 Controller
DCP-MTX incorporates a built-in RS232 controller and is able to power on or off the
display connected to RS232 port by detecting the source status and then sending
corresponding command to the display.
• Baud Rate: Set the Baud Rate for the device connected to the RS232 port.
• Parity Bits: Set the Parity Bits for the device connected to the RS232 port.
• Data Bits: Set the Data Bits for the device connected to the RS232 port.