AMX AVB-DWP-TX-MULTI-DXLINK, Инструкция по эксплуатации

Страница: 68 / 154

Installation and Setup
62 Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Downloading Firmware State and LED Behavior
To monitor the state of a module by its LEDs when downloading firmware, check both the Link/Act and
Status LED columns.
DXLink TX/RX in a Multiple-Stage Switching System
When switching systems with DXLink Technology support (e.g., an Enova DGX Digital Media
Switcher and an Enova DVX-3155HD) are connected via their DXLink ports, DXLink Transmitters and
Receivers can be used to extend the video and audio transport.
Important: This section does not refer to the linking of enclosures from CPU to CPU, which is not
supported in the Enova DGX Digital Media Switcher or the Enova DVX Solutions.
In an installation with DXLink equipment in a multiple-stage switching system, the following apply:

Network loops must be avoided (see page 40). The DXLink line’s Ethernet functionality is
disabled between the enclosures; therefore, no IR, serial, or Ethernet communication can be
passed between them.

When two switching systems with DXLink support are connected via their DXLink ports,
only video and audio will be passed through the DXLink connection.

When a DXLink input or output on one switching system determines that it is connected to a
DXLink input or output on another switching system, the DXLink port will automatically
disable all Ethernet, power, and control on that connection port so that the only things passed
down the DXLink line are the video and audio signals.

When connecting switching systems via DXLink ports, AMX recommends no more than
three switcher throughputs (see the “Example” below).
Example
This example shows how DXLink Transmitters and Receivers can be used in a system where switchers
are connected via their DXLink ports.
The signal path through three switchers could be: source device

DXLink Transmitter

Enova DVX-3155HD, DXLink input (out a DXLink output)

Enova DGX 32, DXLink input (out a
DXLink output)

Enova DGX 16, DXLink input (out a DXLink output)

DXLink Receiver

display device as an HDMI signal.
NetLinx LED Behavior when Downloading Firmware
Downloading Firmware Link/Act LED Status LED
Downloading firmware to flash due to an
upgrade via NetLinx Studio. Fast blink, alternating with
Status LED Fast blink, alternating with Link/Act
LED