AMX AVB-DWP-TX-MULTI-DXLINK, Инструкция по эксплуатации

Страница: 49 / 154

Installation and Setup
43 Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Scenarios / DIP Switch Settings Table
The following table contains the most common scenarios for setting up Transmitters and Receivers as a
standalone pair or with other equipment.
Find the scenario in the table that you want to use and then
set the Dip switches accordingly. A detailed explanation of functions for each toggle is provided on the
two previous pages.
Note: The #1 and #2 Toggles do not apply to the Wallplate TX and Decor Wallplate TX.
Tip: Each toggle’s ON position is toward the connectors on the rear of the DXLink Modules or
toward the top of the unit for the DXLink Wallplate TX and Decor Wallplate TX (see page 40).
* Connect the ICS LAN 10/100 port of the DXLink unit to the network device (e.g., laptop, IP controlled projector,
AMX ICSLan EXB Device). In a standalone setup, connect the ICS LAN 10/100 port of the other DXLink unit to
the network.
** In a standalone setup using NetLinx control of the DXLink serial/IR ports, only one of the DXLink units should
be connected to the network (the unit with #1 Toggle enabled).
Important: When connecting a Transmitter or a Receiver in a standalone pair setup to a Master
(or Virtual Master) for upgrade purposes, #1, #2, and #3 Toggles must be ON.
Common Scenarios DIP Switch Toggle Settings
Standalone Setup – TX/RX pair direct connection 1 2 3 4
AV signals only OFF OFF OFF N/A
AV with Ethernet pass through to networked device*
ON OFF OFF N/A
AV with NetLinx control of TX/RX unit and serial/IR ports**
ON ON ON N/A
AV with NetLinx control of TX/RX unit and serial/IR ports,
plus Ethernet pass through to networked device*
ON ON ON N/A
Switcher Setup – TX/RX with Enova DVX/DGX Switcher 1 2 3 4
AV signals only OFF OFF OFF N/A
AV with Ethernet pass through to networked device*
ON N/A OFF N/A
AV with NetLinx control of TX/RX unit and serial/IR ports
OFF N/A ON N/A
AV with NetLinx control of TX/RX unit and serial/IR ports,
plus Ethernet pass through to networked device*
ON N/A ON N/A