AMX AVB-DWP-TX-MULTI-DXLINK, Инструкция по эксплуатации

Страница: 117 / 154

Appendix B – Telnet (Terminal) Commands
111 Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Appendix B – Telnet (Terminal) Commands
Establishing a Terminal Connection Via Telnet
Telnet terminal communication is accessed remotely via TCP/IP. The Transmitter or Receiver must have
its own TCP/IP address for a Telnet connection. The connection can be started from the Windows
taskbar (see below) or in NetLinx Studio (see the following page).
By default, a User Name and Password are not applied to the Telnet port (Port 23). Therefore, the port
does not require login credentials.
Welcome Banner with and without Security Enabled:

Without Telnet security enabled, a session will begin with a welcome banner similar to the
following:
Welcome to DXLINK-HDMI-RX 0.0.106.0 Copyright AMX LLC 2011
>

If Telnet security is enabled, user credentials are required:
Enter username: admin
Enter protected password: ****
Welcome to DXLINK-HDMI-RX 0.0.106.0 Copyright AMX LLC 2011
>
Note: When security is enabled, a user can retry logging in three times before being disconnected
(for information on setting a username and password, see page 112).
To establish a terminal connection via Telnet at the CMD prompt:
1. From your Windows Taskbar (at the far left), select Start > Run to open the Run dialog box.
2.
Type cmd in the Open field.
3.
C lick OK to open an instance of the Windows command interpreter (cmd.exe).
4.
At the prompt ( > ), type telnet followed by a space and the Transmitter or Receiver’s IP address.
Example:
>telnet XXX.XXX.XXX.XXX
A Telnet session opens for the Transmitter or Receiver and the welcome banner appears.
5.
At the prompt, type the Telnet command (see page 113) and press Enter.