Amtel Direct-Line DL701, Руководство пользователя

Страница: 63 / 69

Error Messages
The Amtel unit is capable of distinguishing between several types of errors. The unit
will try to perform the function requested; however, if the function requested is not
valid, a flashing error message will be displayed. The following is a list of error mes-
sages, the types of situations that invoke them, and suggestions to correct them. (See
the System Administrator for additional information.)
Error Message
Displayed
Flashing Cause Remedy
AUTO
TIME KEEPING
MODE
•
A user is attempting to
change the date/time on
a keyboard unit set to
auto time keeping.
When set to auto time
keeping, time is kept
for all units by the
central timekeeper.
•
Check with the System
Administrator how time is kept for
your network, then refer to the Time
Keeping section.
COMM ERROR
(SEE USER
GUIDE)
•
The address entered is
not the address of any
unit on the network.
•
Receiving unit’s
address changed.
•
Communication path
between the sending
and receiving unit has
been interrupted. The
display will flash the
error message, and will
time out, and the
display will show the
address entered.
•
Check address entered.
1. If the address is incorrect, wait
until the check address error code
stops flashing.
2. The alert/message address will
appear.
3. Press the
SPACEBAR
to get the
cursor.
4. Type in the correct address and
press
SEND
. The communication
was delivered if the display
returns to the idle mode.
•
Refer to the System Administrator’s
Manual.
•
Check the communication path of
both units.
1. Same mode of communication
(fastwire/hardwire).
2. Same zone.
3. Check data cord connections —
is the hardwire cord (looks like a
phone cord) plugged into the I/O
port in the back/bottom of unit
and securely plugged into the
Amtel dedicated RJ-11 jack.
4. Check that power cord or
power/data cord is properly
connected to the back of the unit
and the four pins are straight.
Ve r s i o n 2 . 1
Error Messages 9 – 3
KEYBOARD USER MANUAL
9
Problem Solving