16
NO
NO
A2
A2
A1
T1
T2
T3
L3
L2
L1
M
～
G
N
L
外
接
电
源
按钮开关
N. Tighten all the hose fitting and fill the power unit with Hydraulic Oil.
In consideration of Hydraulic Power Unit’s durability and keep the equipment
running in the perfect condition, please use Hydraulic Oil 46#.
O. Install Electrical System
According to the circuit schematic, connect the power source on the data plate of Power
Unit.
Note: 1. For the safety of operators, the power wiring must contact the floor well.
2. Pay attention to the direction of rotations when using 380V, three phase motors.
Single phase motor
(See Fig. 27).
1. Connecting the two power supply lines (active wire
L
and neutral wire
N
) to
terminals of AC contactor marked L1, L2 respectively.
2. Connecting the two motor wires to terminals of AC contactor marked
T1, T2
.
3. Connecting
A2
to
L2
of AC contactor.
4. Terminal
4#
of control button is connected with terminals
A1
of AC contactor;
Terminal
3#
of control button is connected with terminals
L1
of AC contactor.
Fig. 27
Adjust the moon gear
Tighten the bolts
Fig. 25
Adjust gear and rack meshing.
Fig. 26
Lock the screws by wrench after the gear
and rack are in good meshing condition
单相
Po
w
er
so
ur
ce
Control button
AC contactor
Single Phase
Switch button
Содержание BP-10
